Chevrolet

2010 Chevrolet Avalanche

CRM Mitchell1 2021-02-07T23:00:54+00:00

Mileage

151,264

Service Date

2/4/2021

Services Performed

• DISC ROTOR – Remove & Replace – Rear,Both – [Includes: Replace Pads (if necessary). DOES NOT include refinishing.] IF IT DOESN'T NEED ROTORS IT WOULD BE LESS
• RE-SURFACE REAR ROTORS WITH OUR ON VEHICLE ROTOR RE-SURFACING MACHINE. THE MACHINE SHAVES THE ROTORS OUTER SURFACE SO THEY ARE SMOOTH FOR THE NEW BRAKE PADS.

 

SHANE A. gave our service a 5 star review on 2/6/2021

2010 Chevrolet Avalanche CRM Mitchell1 2021-02-07T23:00:54+00:00

2011 Chevrolet Silverado

CRM Mitchell1 2020-12-23T23:00:26+00:00

Mileage

119,386

Service Date

11/30/2020

Services Performed

• DRAIN OIL. LUBRICATE SUSPENSION PARTS. CHANGE FILTER. FILL WITH SYNTHETIC OIL TO CORRECT LEVEL.

 

KEN B. gave our service a 5 star review on 12/19/2020

2011 Chevrolet Silverado CRM Mitchell1 2020-12-23T23:00:26+00:00

2006 Chevrolet Silverado

CRM Mitchell1 2020-12-05T23:02:18+00:00

Mileage

144,957

Service Date

12/3/2020

Services Performed

• ADJUSTED THE TOE IN AND FOUND THE REST (CASTER AND CAMBER TO BE WHERE THEY SHOULD BE. TEST DROVE TO MAKE SURE IT WAS GOING STRAIGHT AND THE STEERING WHEEL WAS STRAIGHT.
• BRAKE SHOES &/OR PADS – Remove & Replace – 1500 w/Rear Drum Brakes,Rear – [Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishin
• CLEAN THE MASTER CYLINDER CAP AREA AND REMOVE THE OLD FLUID FROM THE RESERVOIR. FILL WITH FRESH FLUID AND FLUSH WITH POWER BRAKE FLUSH MACHINE BY PRESSURIZING BRAKE MASTER CYLINDER AND VACUUMING OLD FLUID OUT OF EACH BRAKE BLEEDER UNTIL THE FLUID IS CLEAN
• CLEANED THE K&N FILTER WITH K&N CLEANING SOLUTION. LET IT SIT OVERNIGHT AND DRY AND RE-INSTALLED.
• DRAIN AND FILL THE TRANSFER CASE
• HOOK THE COOLANT FLUSH MACHINE TO THE RADIATOR HOSE TO REMOVE ALL ANTIFREEZE IN THE COOLANT SYSTEM. ONCE ALL OF THE COOLANT HAS BEEN REMOVED THE MACHINE FILLS THE SYSTEM WITH CLEAN FLUID. START VEHICLE AND LET IT RUN WITH THE RADIATOR CAP OFF
• PITMAN ARM – Remove & Replace – 1500,4WD – [Includes: R&I Steering Gear Assembly.] – [DOES NOT include alignment.]
• REMOVE ALL POWER STEERING FLUID WITH MACHINE AND ADD ADDITIVE TO CLEAN OUT THE POWER STEERING SYSTEM THEN FILL WITH NEW FLUID.
• REMOVE DRAIN PLUG AND USE AIR SYSTEM TO REMOVE ALL OF THE OIL FROM THE DIFFERENTIAL. ONCE EMPTY REPLACE WITH NEW FLUID
• REMOVE REAR DIFFERENTIAL COVER SINCE THERE WAS NOT A WAY TO ACCESS THE FLUID WITH OUR FLUID SUCTION DEVICE.
• REPLACE DRIVER'S BRAKE LIGHT BULB AND THE LICENSE PLATE BULB
• RE-SURFACE REAR BRAKE DRUMS MAKING THE SURFACE SMOOTH FOR THE NEW BRAKE SHOES.
• TIE ROD &/OR END – Remove & Replace – 1500,4WD,Recirculating Ball Type Gears Outer,Both – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing
• WATER PUMP – Remove & Replace – V8,Gas,4.8L Eng w/Air Cond

 

NICK H. gave our service a 5 star review on 12/4/2020

2006 Chevrolet Silverado CRM Mitchell1 2020-12-05T23:02:18+00:00

2005 Chevrolet Equinox

CRM Mitchell1 2020-10-10T22:01:21+00:00

Mileage

116,978

Service Date

10/2/2020

Services Performed

• CHECK OVERHEATING
• CHECKED FOR HEADGASKETS AND THERE WAS NO INDICATION THAT THE HEAD GASKETS WERE BAD. REMOVED THE HOSES ON THE FIREWALL RIGHT AT THE HEATER CORE TO SEE IF IT WAS FLOWING AS IT SHOULD. NO FLOW OUT OF THE HOSES SO IT LOOKED LIKE IT WOULD BE THE WATER PUMP. REMOVED THE PUMP AND FOUND THE IMPELLER ON THE WATER PUMP TO BE SPINNING AS IT SHOULD AND SINCE THE FINS ON THE PUMP ARE METAL THERE WERE NO ISSUES WITH THE FINS. REMOVED THE RADIATOR AND FLOW TESTED IT AND THE RADIATOR WAS FLOWING AS IT SHOULD. REMOVED THE THERMOSTAT. PUT IT IN HOT WATER AND WHEN THAT HAPPENS THE THERMOSTAT SHOULD OPEN ALL THE WAY BUT IT WAS ONLY OPENING PARTIALLY. REPLACED WITH A NEW UNIT BUT IT CONTINUED TO OVERHEAT. ONCE THE HEADGASKETS WERE REMOVED WE FOUND ONE OF THE GASKETS TO HAVE A PARTIAL TEAR IN IT CAUSING THE VEHICLE TO OVERHEAT.
• RE-SURFACE HEADS

 

ANTOINETTE F. gave our service a 5 star review on 10/8/2020

2005 Chevrolet Equinox CRM Mitchell1 2020-10-10T22:01:21+00:00

2005 Chevrolet Equinox

CRM Mitchell1 2020-08-15T22:01:58+00:00

Mileage

156,284

Service Date

8/8/2020

Services Performed

• FOUND IT NEEDS CONTROL ARM BUSHINGS AT SOME POINT AND IT NEEDS SERPENTINE BELT

 

WALT B. gave our service a 5 star review on 8/13/2020

2005 Chevrolet Equinox CRM Mitchell1 2020-08-15T22:01:58+00:00

2010 Chevrolet Malibu

CRM Mitchell1 2020-01-07T23:01:27+00:00

Mileage

147,893

Service Date

12/20/2019

Services Performed

• ADD BG FLUSH TO THE ENGINE AND LET RUN FOR 15 MINUTES AT 1200 RPM. CHANGE OIL AND FILTER AND ADDED BG MOA
• CHECKED THE CODES TO SEE WHY THE CHECK ENGINE LIGHT WAS ON. FOUND CODES POINTING AT THE VARIABLE VALVE TIMING ON THE FOR THE EXHAUST. FOUND THE OIL LEVEL TO BE VERY LOW. SO WE PERFORMED AN OIL FLUSH. ONCE WE DROVE IT WE CHECKED TO SEE THE FUNCTIONALITY OF THE VVT SOLENOID FOR THE EXHAUST. IT WASN'T FUNCTIONING. ALSO FOR THE COOLANT IT HAD A CODE FOR LOW COOLANT. PRESSURE TESTED AND CHECKED FOR LEAKS AND NO LEAKS WERE FOUND.
• NOTICED
• VARIABLE VALVE TIMING SENSOR – Remove & Replace – In-Line4 Camshaft Position Sensor,One,Intake or Exhaust – [NOTE: Labor estimates listed are for R&R only and DOES NOT include diagnosis time.]

 

RANDY G. gave our service a 5 star review on 1/4/2020

2010 Chevrolet Malibu CRM Mitchell1 2020-01-07T23:01:27+00:00

2010 Chevrolet Avalanche

CRM Mitchell1 2018-12-21T23:00:22+00:00

Mileage

107,486

Service Date

12/12/2018

Services Performed

• SHOCK and /OR STRUT ASSEMBLY – Remove and Install or Remove and Replace – Both – [DOES NOT include disassemble or alignment (where applicable).]

 

GARY S. gave our service a 5 star review on 12/18/2018

2010 Chevrolet Avalanche CRM Mitchell1 2018-12-21T23:00:22+00:00

2010 Chevrolet Malibu

CRM Mitchell1 2018-11-07T23:00:59+00:00

Mileage

146,635

Service Date

10/30/2018

Services Performed

• TIMING CHAIN
• BALANCE SHAFT CHAIN – Remove and Replace – In-Line4 – [Includes: R and I Camshaft Drive Chain.]

 

DENISE O. gave our service a 5 star review on 11/2/2018

2010 Chevrolet Malibu CRM Mitchell1 2018-11-07T23:00:59+00:00

2007 Chevrolet Malibu

CRM Mitchell1 2018-10-31T22:01:13+00:00

Mileage

116,129

Service Date

10/24/2018

Services Performed

• INSTALLED THE BRAKE SWITCH AND RE-CALIBRATED IT.

 

MARIA B. gave our service a 5 star review on 10/27/2018

2007 Chevrolet Malibu CRM Mitchell1 2018-10-31T22:01:13+00:00

2010 Chevrolet Malibu

CRM Mitchell1 2018-04-06T22:01:17+00:00

Mileage

61,614

Service Date

3/20/2018

Services Performed

• DRAIN FLUSH AND REFILL COOLING SYSTEM
• FLUSH BRAKES AND REFILL FLUID
• FLUSH THE TRANSMISSION USING THE TRANS TECH FLUSHING MACHINE

 

MARY R. gave our service a 5 star review on 3/22/2018

2010 Chevrolet Malibu CRM Mitchell1 2018-04-06T22:01:17+00:00